Interested to Buy Any Domain ? << Click Here >> for more details...
how to find number of run for transformer & alternator
secondary side? give the example.
- 2 Answers
- 5419 Views
- Powergear, Regen Powertech, I also Faced
- E-Mail Answers
Answer Posted / firoz n
Runs actually depends the transformer capacity ,secondary
current ie, the load demand
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What happens if the series current double?
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
What is the physical significant of power factor?
how to calculate the Neutral transformer impedance?
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
what is your aim
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
oil cooled transformer
Explain what is clipper and clamper circuits?
Define characteristics impedance?
how to decide the capacity of accl
Explain the operation of variable frequency transformer?
In radial network the source is fed from 1 end both ends at central
