Interested to Buy Any Domain ? << Click Here >> for more details...
Why a starter is used for a motor?
- 50 Answers
- 150227 Views
- L&T, Nilachal Polytechnic, I also Faced
- E-Mail Answers
Answer Posted / boobesh
1.To limit the starting current
2.To provide against low voltage and over load condition
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
What is the type of feedback used in an op- amp schmitt trigger?
Comparision of Air break circuit breaker, SF6 Circuit breaker and vacuum circuit breaker.
Where can i get practical knowledge of solar system?
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
what are the steps involved in generator load test?
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION
what is advertised hop count
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
Difference between Earthing Truck & Earthing trolly for HT panel
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
What are m circles?
How to select HT/MV cable size ?
A jet of fluid strikes a plate What was the force required to counter it?
