Interested to Buy Any Domain ? << Click Here >> for more details...
If a transmitter is installed 10 m below its tapping point how much pressure exerted if fluid is water?
- 10 Answers
- 15817 Views
- QAFCO, I also Faced
- E-Mail Answers
Answer Posted / dilip kumar jha
Tx. will showing pr. 1kg/cm2
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain PID, ON/OFF, Controls
How to calibrate Magnetic flow Transmitter in Field
can we create an interrupt in plc through scada?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
all types of liquid analyzer principle with drawing?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
Working principle of magnetic flow meter ......and calibration procedure of e+h magnetic flowmeter...
selection criteria of control valve? and selection criteria of actuator explain in brief?
applications of plc in printing and packaging?
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
What is the use of GMV in turbine?
how can leve transmetter calibate in feild .and also put cv and flow plz .....
what is zero and span ?
