Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / jyoti-theboss
Induction motor works on the Faraday's law of mutual or
electro magnetic induction.Which states that if" Two coils
are inductively coupled(not electrically connected,but
closely connected without touching each other so that,flux
linkage can occur),if current flows in one circuit there is
production of emf in the neighbouring circuit.
so if power supply is given to the stator winding a
magnetic flux of constant magnitude but rotating at
synchronous speed is set up.it sweeps past the rotor
surface & cut the rotor conductors and emf induced in
them.As per Lenz's law"It opposes the very cause producing
it".So to reduce the relative speed (between rotating flux
and stationary rotor conductors) rotor starts running in
the same direction as that of the flux.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
How we can calculate the consumption in kwh of motor on basis of kw @100% load, @50% load & @ no load.
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
How to calculate that clean water supply in one Day from 150 KLD STP?
What is meant by turbo alternators?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
What is the role of power pack in substation protection system?
What is MS-EXCELL?
how to measure dc earth leakage current?
what is the responsibility of C license holder in industry?
Why 9KV surge arrester having 7.65KV of MCOV?
for what purpose the star point is done in ct
what is the circutor?why we use it ?
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
I am inpecting a 10kVA UPS what tests should i do and should i observe?
