Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERENCE BETWEEN A TRANSMITTER & A SMART
TRANSMITTER.
- 8 Answers
- 42665 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant
SMART- SINGLE MODULE AUTO RANGING TRANSMITTER
SMART transmitter are compatible with a Digital
Communication protocol device which is a HART Communicator.
with the help of HART communicator we can share and send the
both Analog & digital Parameter with intelligent or SMART
instruments and also can do on-line calibration with out any
external variables.
only HART protocol device used with SMART transmitter
because of both analog and digital communication.
NON-SMART tx. can not communicate with hart and can not do
like SMART
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
Conversions
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
Explain bernoulli’s theorem. State its application.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
full process of gas turbin?
Which is your favourite subject & explain any one topic of it.
what is function of switch, and how is it work, explain with difination
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
what is the reason while warning lamp is on while the engine is cranking?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
how to calculate the total flow in square root
