Interested to Buy Any Domain ? << Click Here >> for more details...
what is purpose of three way manifold valve using for dp
transmitter
- 1 Answers
- 8868 Views
- I also Faced
- E-Mail Answers
Answer Posted / surendar
1) to isolate LP,HP.and check the zero calibration
2)For flashing the impales lines manifold should be close
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Identification of ss fittings, pilot valves, relief valve.
whats the abbreviation of IOP? is it instrument of power or input open problem?
What is super thermocoupal?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
what are the selections available in configuring a burnout protection of a controller? thanks
what is actual drum level and compensated drum level?
How is work 5/2 sov?
principle of automatic votage regulator
How to Calibrate Level Switch in field
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
kindly sent some demo question and answer
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
what is the procedure of belt scale calibration?
