Interested to Buy Any Domain ? << Click Here >> for more details...
If Solenoidal valve works in manual mode but not in Auto
mode. What should be the problem?
- 8 Answers
- 11625 Views
- Bharathi Cement, Titanium, I also Faced
- E-Mail Answers
Answer Posted / fellyc
Assume that both Manual Command (PB) and Auto signal comes
from the DCS ( Same DO).
If it works in Mamual Mode and not in Auto Mode, then check
the logic for an interlock or permissive.
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
what is loop1 and loop2 in MTS LT?
What materials are used in thermo wells?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
how can use ram
How is PH sensor works ?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
how can leve transmetter calibate in feild .and also put cv and flow plz .....
draw shematic diagram of c/v positioner(smart type)?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
What is the reason PT speed not incresed in gas turbine?
why any measurement made interms of pressure is more accurate ? to be more precise most of the flow velocity is made interms of pressure and it is accurate. what is the reason behind pressure measurement being accurate ?
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
How process line mpm calculation is done?
