Interested to Buy Any Domain ? << Click Here >> for more details...
1. which type of transformer connection is preferred in
case of power supply transformers?
(A) Star/Star
(B) Delta/Delta
(C) Star/Delta
(D) Zig Zag/Star
2. In a power transformer usuall which winding is closer to
the core?
(A) Primary winding
(B) Secondary winding
(C) Low Voltage winding
(D) High Voltage winding
3. The power factor of a purely inductive load is
(A) Zero
(B) Lagging
(C) Leading
(D) Unity.
- 9 Answers
- 12603 Views
- CECRI_Central_Electrical_Research_Institute, I also Faced
- E-Mail Answers
Answer Posted / shah faisal
Q1.C
Q2.C
Q3.A
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is frantic effect?
IN SINGLE PH TRANSFORMER IF LEKAGE IMPEDANCE DROP IS NEGLECTED ,THE FLUX IN THE MAGNETIC CORE and the lekage flux linking a winding are a)proportional to the applied v to the winding i respectively.
what parameters should we check to reduce the power bill
how we calculate electrical load on a building according to area?
how braking & making capacity of circuit breaker are calculated?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
to vary valtage from 0 - max a variac is necessary . so how to design for high power applications nearly about 200KW power
where is core-type and shell-type construction suitable for transformers ?
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
Define noise?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
What is the normal phase difference between the voltage and the no-load current in a transformer?
