Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference between 3 wire and 4 wire RTD sensor?
- 12 Answers
- 43792 Views
- HTA Instrumentation, I also Faced
- E-Mail Answers
Answer Posted / saravanan
In RTD 2-wire - lead wire resistance can drastically reduce
the accuracy of the measurement by adding additional,
uncompensated resistance into your system.
In RTD 2-wire - Third wire to help the circuit compensate
for lead wire resistance and thus provide a truer indication
of the measured temperature.
In Four wire RTDs we can obtain slightly better
compensation, but are generally found only in laboratory
equiptment and other areas where high accuracy is required.
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
field bus transmitter calibration procedure tell me
what is the process for double acting cylinder pneumatic for 32' v/v
which type of zones used for boiler? & why ?
Explain the working of an enraf level gauge.
What are the type of bonnets in the control valves?
HI friends.I am Surya a BTech in Electronics and Instrumentation Engineering.I am going to appear Relince Industries Ltd all India writen test very soon. so plz help me by sendind the probable questions about my subject.My mail ID is surya.barik@gmail.com.
What is the minimum rating availalbe for weld neck orifice in market?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
what is the difference between scaler and vector drive
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
what is the responsibility of an instrument commissioning supervisor
How d.p. Transmitter can be applied to close tank?
Difference between dcs and plc including date processing and architecture.
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
what are the values of fuel flow rate in various places in boiler.
