how and why are capacitors are used to improve powerfactor?
- 4 Answers
- 5423 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
BECAUSE IT GIVES LEADING POWER FACTOR WHICH BRINGS THE POWER
FACTOR CLOSE TO UNITY AND SUPPLY MAX ACTIVE POWER
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why do we require transformer with less specific weight if supply frequency is increased?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
State and define ohm’s law?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
1.what is the difference between ct and cvt? 2.what is the difference between pt and cvt? 3.what is the difference between relays and circuit breakers?
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
what is the isolation transformer. what is the isolator?
Mention how NPN and PNP transistor works?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
Is Transol transformer oil comparable to nynas nytro libra?
how to calculate fault level?
what does a k rating in a transformer means?
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com
