Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / guna sekhar
induction motor draws 4times the load current of motor intially. so we use star -delta starter to reduce intial current . first the windings connected in star thereby reduces the intial current by 1/../3[root3].after certain time delay its converts winding connection to delta.
| Is This Answer Correct ? | 6 Yes | 8 No |
Post New Answer View All Answers
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
when 20hp 3 phase motor start no load condition in star or delta connection.find current and write formula.(tariq)
how net resistance islow in star connection and viseversa in delta connection...? if anybody could explain in detail it wud be helpful.
How many devices can be connected in one zone of FACP
what is the working principle of energy saver control panel. please give the complete calculation & theory.
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
what purpose to use excaiter in DG.?
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
Is any generator is developed which is operated with out diesal or other expensive source?
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
briefly explain the main blocks found in a microprocessor based system
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
On what basis the the size of Lightning arrester for buildings are selected ?
at which voltage level arcing ground is occurs ??????????
