Interested to Buy Any Domain ? << Click Here >> for more details...
How to isolate a DPT from line in the condition that process
must not be disturbed,and process is also critical and no
bypass is available.?
- 4 Answers
- 11061 Views
- Descon, I also Faced
- E-Mail Answers
Answer Posted / lal
we can set the actual value & activate a Timer from the DCS , within in the time which set on the DCS we can isolate the transmitter from the line , and it will not affect the process , the timer is used for safety purpose , we cannot activate it more than a limited time.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why we r opening HOT BYPASS valve during startup of a compressor?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
why is an oxygen sensor used in a boiler stack
How we calculate orifice plat size???
how to connect transmitter measuring sulfur process? 1-by using long impulse line or 2- by using coated short impulse line
what is function of switch, and how is it work, explain with difination
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
How to Calibrate Vortex Flow transmitter in field
What is frequency factor in massflow meter? When using frequency output?
What are different types of orifice plates? State their uses.
Derive capacitance to 4-20ma conversion formula / relation in capacitance type pressure sensor?
what are the use of belew gear in general ??
why orfice is not used for main steam flow calculation
