Interested to Buy Any Domain ? << Click Here >> for more details...
y v r connecting 250 ohms resistor in series when u
cummunicate with BT in bench calibration?
- 5 Answers
- 8618 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikash suthar
It is because the BT only work if the input impedence is in
the range of the 250 to 600 ohms. so to do make it
communicate we can connect not only 250 ohm but from 250 to
600 ohm any resistor can be connected.
I have experience that even if we connect resisatance 100
ohm it works . below it ,BT not work and up to 900 ohm it
works .but the advisable is from 250 to 600ohm.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
if my flow is 20000 m3/h than which range of DPT i have to use????
protection relay watchdog contact operation?
give me the formula for analog to digital converter and also d to a converter
how to calibrate and troubleshooting of leveltroll?
give some question relative instrument fitter?
how to calibrate steam control valve in steam turbine
Explain the burnout feature.
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
What is ultrasonic flowmeter?
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
Why is it necessary to use compensation leg to measure the liquid level in a closed or pressurized tank?
Why are the uses 24vdc in industries
why direct mounted pressure transmitters is always installed with DBB ( double bleed block) valve in process line or top of the tanks ?
why is an oxygen sensor used in a boiler stack
How to convert milliampares into flow??
