Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / d das
A programmable logic controller (PLC) or programmable
controller is a digital computer used for automation of
electromechanical processes, such as control of machinery
on factory assembly lines, amusement rides, or light
fixtures. PLCs are used in many industries and machines.
Unlike general-purpose computers, the PLC is designed for
multiple inputs and output arrangements, extended
temperature ranges, immunity to electrical noise, and
resistance to vibration and impact. Programs to control
machine operation are typically stored in battery-backed-up
or non-volatile memory. A PLC is an example of a hard real
time system since output results must be produced in
response to input conditions within a limited time,
otherwise unintended operation will result.
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
How to Calibrate Ultrasonic Level Transmitter in field
What are different types of orifice plates? State their uses.
Why ac supply load cell is used? Can we use the dc supply load cell?
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
What are the interlocks we have to check during the start up of LP/HP compressor?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
what is intrinscily safe system and where we use?
all types of liquid analyzer principle with drawing?
What is the diffrence between ff tx and non ff tx
Explain why plc require in analog input 4-20amp & 0-10 volt?
How earthing can be checked????
What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem?
