Interested to Buy Any Domain ? << Click Here >> for more details...
y v r connecting 250 ohms resistor in series when u
cummunicate with BT in bench calibration?
- 5 Answers
- 8457 Views
- I also Faced
- E-Mail Answers
Answer Posted / prashant pandey
As per my knowledge we usually connect resistor in series to
limit the current to successive device... Here also it
serves the same purpose...
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
Coal mill Instruments Equipments for cement plant And process diagram ?
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
How many interlocks at turbine? Plz explain briefly
1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.
What are different types of orifice plates? State their uses.
any questions on motor and energy conversions machines?
How to calibrate capillary type level transmitter
what is the imbustion control loop
how to calibrate Necleuonic level transmitter.?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what about your moleg in pogrees with company
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
Explain the combusion chamber
