Interested to Buy Any Domain ? << Click Here >> for more details...
In a 3Ph induction motor(old) 6 wires came out from terminal
& not mentioned u1,v1,w1,u2,v2 & w2. how can find out the
terminals? how can connect to star delta starter??
- 1 Answers
- 11047 Views
- I also Faced
- E-Mail Answers
Answer Posted / raovasuki17
first of all you have to use multimeter to identify the
coil teminals. segregate it in two lines as 2 x 3 . ie top
3 terminals and bottom 3 terminals.
Next take a Small DC power supply with 3 volt and a
milliampere meter( DC ). connect this voltage to one of the
coils with milliampere meter in series( Milliampere meter
should be of center zero type ) close the supply voltage to
the coil with make and break it immediately. observe the
deflection whether it is on forward side or reverse side.
and mark one terminal for whcih +ve suplly is connected as
Start and the other ( _ ve )end as Finish. do this
process for other two coils also. once you know the top 3
start points and finish points of the coil. you are almost
there. now you short ckt all finish ends. you are left
with 3 start terminals. ie your STAR connection.
For Delta connection connect finish end of the first coil
to start end of the second coil, finish end of second coil
to start end of third coil and finish end of 3third coil
to start end of first coil. now you have theree junctions.
now your connection is in Delta mode.
| Is This Answer Correct ? | 17 Yes | 2 No |
Post New Answer View All Answers
Did RMU have ct and pt ?
How can a equal potential zone be carried out in conductors?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
What is a commutator?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
What is bridge rectifier and explain with details
How to set a Zone 1 distance relay for distribution feeder?
what is the function of Moulded case circuit breaker, why it is called Moulded?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
sir, iam a electrical engg graduate and i want to go in automation sector and for this i have decided to do industrial training for this,plz suggest me some good institute for the same in delhi,ncr. my degree percentage is 58%, can i get job after doing training, plz help....
how can check the resistance of battery contact?
condition Autotrip facia come on control panel of electrical transmission line?
what is difference between 5A and 100A CT constructional wise and operation?
what is the clear formula to calculate cable size for a load
can we install HT panel & LT panel side by side or how much clearance is required ?
