Interested to Buy Any Domain ? << Click Here >> for more details...
can motors working at parallel operation like D.G set and
transformers? It means asking about two motors coupled with
same load???
- 1 Answers
- 3986 Views
- I also Faced
- E-Mail Answers
Answer Posted / raovasuki17
Yes., Motor can work in Tandem for the same load. Some
times when the load is too much we can use two motors with
geared coupling ( Direct) or indirectly coupled through
wire or felt or sprocket and we have to use load sharing
technology ( Available in Electronic drives )
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
all details of DG UPS HVAC
STATE USE OF ARC RUNNERS & SPLITTERS ?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
What is CVT and what is relation with wave trap?
What kind of preventive maintenance are there for transformer?
what is the relative size of single and three phase?
Define what is difference between fuse and breaker?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
How isolater function when installed inelectrical 440V wiring
why we are not giving the zone 1 trip command to the master trip relay
Difference between Lugs and Thimbles
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
