Interested to Buy Any Domain ? << Click Here >> for more details...
Which one is correct mVA or MVA. Whether both the units are
same for the transformer
- 10 Answers
- 15640 Views
- Areva, I also Faced
- E-Mail Answers
Answer Posted / pinku
MV.A (not 'MVA') is the symbol for megavolt ampere.and in some low volatge cases we consider VA that is (Voltage Ampere). where VA is the true vector sum of circuit power or reactive power.
So, i thik it is true. NOT 'mVA' in case of transformer.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the advantages of instrument transformer?
What is boucholz relay and the significance of it in to the trformer?
700KW 6.6KV slip ring induction motor to use VFD to control the speed
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
How do we calculate over and under frequency tolerance from generator data?
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
how generator avr give to the input?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
why in the three pin plug all 3 pins are cutted ?
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
describe the Tranformer testing procedure
what are the applications of PLC?
