Interested to Buy Any Domain ? << Click Here >> for more details...
why buchholz relay installed in inclined position
- 3 Answers
- 12198 Views
- Eskom, I also Faced
- E-Mail Answers
Answer Posted / alok singh
Buchholz relay is installed in inclined position because of its function as it is used for internal fault protection inside the transformer as in case of over heating and loading of transformer oil temperature also increases hence oil expands inside the body of transformer so that excessive oil expands during heating or time of fault enters in buchholz relays body and after a particular level relays coil get trips and gives an alarm to the operator regarding the fault.
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
Why PS class CT is always preferred for Differential protection?
What is block diagram?
how to find number of run cable laying[LT side] for transformer & alternator secondary side? [above condition for getting output power transformer to main panel side] give the example.
what is resver in electrical enginnering with answer
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
my question is how to answer the question "you are from b.tech eee background and why do you want to go for banking
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
I completed my BE EEE degree 2006 .... which license should i apply .... ?????
Meter p.t. ratio= 3×230/400 , c.t.ratio = 3×1 (2) A what is m.f.
Can you please explain creepage distance in detail, for a 6.6kV cable head what must the distance be and how do you determine it?
How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
how to calculate transformer load?
