why we did not get shock by touching nuetral of any single
phase supply of a electrical equipement?
- 6 Answers
- 10309 Views
- I also Faced
- E-Mail Answers
Answer Posted / latha
First we have to understand by neutral grounding i.e,when any phase of an electrical equipment is connected to the ground by using a resistor or any non electrical part, then even though we touch the neutral wire , we can't feel any shock because the heavy currents or fault occurs it goes through the ground and then to the source part.......there is no shock that we can feel by touching the neutral.....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
.php|
How may I get the maximum current capacity for a particullar size Alluminum or Copper cable if there is compulsion to use?
Describe the test procedure to determine the vector group
How equivalent impedance is calculated in thevenin theorem?
what is the voltage between earth to neutral in lift.
as a electrical student why should i hire you?
1.what is mean by 8/20 micro sec waveshape
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
What is meant by bus bar protection?
Draw the single line diagram of the power station?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
which is chemical used as in ro water what is difference betweeen multi grade filter&dual media filter
wow to calculate the transformer rating(KVA)
What is the use of mc( moving coil) in dc voltmeter and dc ammter and what is the use of ( moving iron)in ac voltmeter nd ac ammeter
