why we decide alternating wave form in ac system and not in
dc system
- 2 Answers
- 3833 Views
- GMR, I also Faced
- E-Mail Answers
Answer Posted / mubeen
DC system is expensive and have less quantity of voltage
than Ac system.Ac system consuming less power than DC
system.AC power can be easily reduce or increase (step up /
step down ) by the transformers.But for DC required so many
equipment to increase the voltage flow.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
Air refrigeration cycle works on the
What is self exciting?
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
What is the maximum operating temperature for a thermoplastic insulated cable?
Name two low frequency oscillators?
what is the necessity of under ground cables ??
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
wheather the size of windings in motor and generator are the same
what is gas turbine intercooling ?
can some one clearly explain why -48 volt DC use in telecom site????
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
what is 400kv doble circuit quadpole tower?
What is stepper motor. What is its uses?
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
