Answer Posted / muthuvel
If the power system dont have balanced load distribution
between the phases(R,Y,B),The neutral line will get flow of
current. The load distribution(R=Y=B)for the Phases should be
equal
then only the power quality will be high and the Neutral
current will be 0 too...
| Is This Answer Correct ? | 24 Yes | 1 No |
Post New Answer View All Answers
What do you understand by oldham's coupling ?
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
What if high voltage side circuit breaker of a ehv transformer instead of lvcb? Kindly elaborate.
where lt & ht capacitor used
what are the installation procedure of high voltage power transformer,CT,CB&PT?
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
why do we not use equivalent voltage source in negative sequence equivalent ckt.
What type of a DC motor would you use for a lift?
How equivalent impedance is calculated in thevenin theorem?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
draw 3 phase rectifier diagram
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What are m circles?
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
