Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / tushar srivastava
Hi, This is Tushar Srivastava. See, There is a simple reason
for your question, it is called symmetry. Yes, it is only
the symmetry. Actually, the general purpose LM741 opamp has
only 7 working pins. If you will take a look at the pin
diagram it says that pin 8 is not connected (NC). This means
that pin 8 is not connected to anything inside the IC. It is
just a dummy pin which is only meant to make the design of
DIP casing, Symmetrical. No more reasons.
Thank you.
| Is This Answer Correct ? | 8 Yes | 9 No |
Post New Answer View All Answers
What is meant a parallel inverter?
What are the drawbacks of walsh codes?
How can we remove unwanted sideband from ssb modulation?
how to use single phase supply for 3 phase instrumentation
WHEN SUB. A IS HPLMN AND B SUB. IS ROAMING FROM ANOTHER PLMN CAN ANY ONE TELL ME THE CALL FLOW FOR THIS?
Why is collector region is greater than emitter region?
why we are using the bridge rectifier in most of the circuits instead of full wave rectifier even though the output of both are same?
What are the poles of alternators made of?
Explain what is a differential amplifier?
What is meant by cyclo-converter?
5. What is the maximum transmit power of FlexiEdge BTS
Im Simil,doing 6th semester Electronics & Communication Engineering.After completing my course I would like to be an integral part of Siemens technology.For dat when & how shoult I apply?
Explain the operation of 1φ ac voltage controller with rl load?
What is the use of excitation table in digital electronics?
What are the advantages and disadvantages of jfet over bjt?
