Answer Posted / sohail
In star connection Phase voltage and line voltage are not equal where as phase current and line current are equal.when three phase current are same.at that time load on generator is symmetric whereas any change in phase current that result a fault current generate and that fault current is used for generator protection.that why generator is star connected for protection purposes 4 identification of fault current.
| Is This Answer Correct ? | 19 Yes | 7 No |
Post New Answer View All Answers
why Y CONNECTION IS BETTER INTERMS OF EFFICIENCY AND P.F FOR A LAOD LESS THAN 40% AND WHY AFTER DELTA IS BETTER FOR > 40%
what is 3rd Harmonics? how it is generated in alternator
what is rocking arrangement in arc heating
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
what is the calculation method to design core and winding of a 200kva 3phase distribution transformer?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
How many devices can be connected in one zone of FACP
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
What is the name of the winding to which supply is given?
what is the constructional difference between a power transformer and potentian transformer?
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
why the name trunking bus PT
