In India,we use 230V,50HZ,where as many other countries use
110V,60HZ what r d advantages and disadvantages of each of
them?
- 8 Answers
- 27121 Views
- GVK, I also Faced
- E-Mail Answers
Answer Posted / shiela
High voltage supply makes the appliances run with a smaller
resistance for the same rated current. Since the resistance
is small,losses will be lesser. so India uses 230 V 50 Hz.
| Is This Answer Correct ? | 1 Yes | 6 No |
Post New Answer View All Answers
What happens if we run alternator on under frequency?
what is the advantage of connecting capacitors in delta than in star?
How to Decide the Location of Earth pit for Compressor in Oil Depo? and How to measure the resistance of earth pit Pls explain me with the help of Circuit Diagram?
where lt & ht capacitor used
what kelvin's law ?
Whether IP65 enclosure box blocks ventilation if driver for LED have to enclosed inside IP65 box
What are the different towers used in 132kv transmission line? what are the differences between the P,R,S towers used in 132KV and detailed explanation
what is doubling factor in making current of a breaker?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
what is the meaning of impedance protected in instrument cooling fan
surge tank, hrc fuse, earthing transformer, firm power objective type
Operation carried out in thermal power stations?
what is parellel power factor correction?
