what is the use of megger? and types
Answer Posted / y.rajasekhar reddy
all mggers are insulation resistance testers offer the
electrician, maintenance engineer, and repair technician
flexibility, versatility, and capability of equipment.
there also used the all type of insulation test for cables.
Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
What is the effect of positive feedback on the stability of the systems?
why occ characteristics of generator is also called as magnatization characteristics ?
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
how much maximum load a 2 core (Single phase) 16mm aluminium wire can take ?
Where can i get practical knowledge of solar system?
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
How many sprinklers should be in one pipe line?
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
PAC and simple Ac different
What is the purpose of stablization resistor in high impedance bus bar protection
is it value of power factor is more than unit. whats effects in the source supply