Interested to Buy Any Domain ? << Click Here >> for more details...
. Is there a simple method to measure the horsepower of a
small motor (1-3 hp) for a non-technical person
- 2 Answers
- 4954 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijay balu raskar
Yes, it is very easy to measure by non-technical person by force or pressure handling capacity of the motor which is practically done in many rural non technical persons.
Also, we can calculated or measured by wattmeter for measurment.
1HP = 746 Wattmeter
and by multiplying we will get more.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
how ceiling fan worked?
How can we calculate strength of copper hich is supplying electric power to heater and in it hold the heater also and what r all types of forces which is acting on it...
Explain the operation of variable frequency transformer?
lamination figures
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how to check three phase motor torque value?
What are the special cables required for explosion proof wiring?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
a 230v transformer with step down ratio 19:1.it has 2000turns on primary and rated 25va calculate max primary current no of secondary turns volts/turn
what happen if the parallel generator phase angle shift by 1 degree in manual mode
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
