Answer Posted / zuheir beilouni

Use a current source to calibrate the I/P converter error ,
but if the error was in the valve , calibrate the valve
positioner using Wallace and Tiernan calibration box or for
fast calibration couple a monostat gauge to calibrate and
if both were ok problem lies in the solenoid then check the
supply to it

What do you know about gail?

2470

---

hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?

2102

---

Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.

2012

---

what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.

1972

---

I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration  So is there any causes biside this or  any  permissives ?

1853

---

What is rang ability?

2342

---

Why mmwc unit is used?

1196

---

Difference between ultra sonic flow meter

1993

---

What is the difference between mmwc and mmwg?

1377

---

Why humidity limit is 30 to 55 % for raw material storage?

4284

---

How d.p. Transmitter can be applied to close tank?

1027

---

Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...

2346

---

There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?

1961

---

What is the cascade control

1419

---

for oil & gas industries which zone is normally preferred? why? give its example?

1996

---