Is it benefitial to supply 210v ac to lighting fixtures
instead of 240v ac?
- 2 Answers
- 3334 Views
- I also Faced
- E-Mail Answers
Answer Posted / shyamal h. mandirwala
Yes it is.p=VI as V decreases ,P decreases.However some
ballasts might not pick up if voltage is very less.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
how to find the torque of the single phase synchronous motor by doing an experiment
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
How to address the servo drive for motor
block diagram of 2 ups system connected in parallel mode?
How we calculate the current carrying capacity of H.T. cabel?
how to i get B licence,i am completed BE electircal and electronics engineering.i want to konw the proceduure to get b licence
how to calculate fault level?
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
why fractional pitch winding generally used in alternators?
how we can adjust for three phase motor cold stall time ,hot stall time and thermal register set up?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
what will happen if frequency is below 50 hz?
