Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / akhilantivirus
ELECTRONICS name itself indicates that it is the mechanism of electrons/electron mechanism that undergoes in various components or devices like resistors, capacitors, semiconductors etc.,
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is controlling card in dcs? how u measure dcs memory?what is bus in dcs?how u know dcs speed n ehternet speed?
Why are the uses 24vdc in industries
Positioner usage.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
why we take %i0.0 as input for twido plc
With N nodes and B branches what will have a network ???
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
ORP sensor working principle?
how do we commission inergen system?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
If P will increase then what will happen with PID?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
How flow can be measured with dp?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
