Interested to Buy Any Domain ? << Click Here >> for more details...
What is the measuring unit of tensile strength in Gray cast
iron ?
- 2 Answers
- 4594 Views
- Mico, I also Faced
- E-Mail Answers
Answer Posted / ravi
N/mm2 same as stress
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
If anybody have the ref. design book of the 3 point cylindrical rolling with sheet thickness of 2.3 mm & 67 mm internal diameter legth of 80 mm
WHat is adsl?
What does f.o.f. Stand for in piping design?
increase in unit speed increases the discharge of impulse turbine how?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
thermal engineering
Define isometric drawing?
What is meant by laminar flow ?
What is orthographic drawing?
Where pneumatic system is used?
Dear all i have applied for section engineer post in RRB Chennai can anyone please send previous question papers please do it if u have
the avg piston speed of an internal combution engine increases as cylinder dimension decreases justify?
L&T construction mechanical questions
What is extrued aluminum?
What are the different parts of impulse reaction turbine?
