what is the gas pressure at normal & operating conditions of
sf6 cb??
- 2 Answers
- 4018 Views
- I also Faced
- E-Mail Answers
Answer Posted / tanmay kumar
GAS PRESSURE-7MPA in normal condition.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Difference between ac parallel circuit and ac series circuit?
How to calculate VA rating for CT or PT or Control Transformer?
Why squirrel cage motor can only use with low starting loads ?
Why is tan-delta test and capacitor measurement done on alternator?
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
When lag/lead/lag-lead compensation is employed?
where the lexical paramater will use in fron end?
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
What is milivolt dop test in Busducts? What is its significance & procedure to do the test?
Why colled 440V to 3-phase supply.
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
how to differentiate a mpcb,mcb with a contactor? Explain their working operation
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
What is power relay?
