Interested to Buy Any Domain ? << Click Here >> for more details...
can we make a loop
between neutral and body
for grounding?
- 2 Answers
- 5006 Views
- I also Faced
- E-Mail Answers
Answer Posted / tanmoy
neutral and earthing both are grounding but
individually,both grounding should not be mixed any where
because earthing used for short circuit current from
installed machine to ground for protecting leaving beings or
machine but neutral is used for returning cable/for complete
any circuit.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Name two low frequency oscillators?
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
where solid grounding and where grounding through ngr done and why?
What is purpose of reactor?.What is different between line and bus reactor?
how i can calculate the size for fire cable
Which type of air compressor is used now a days in the market. Keeping in mind of energy efficiency and maintenance points. Relevant documents may also be sent on mentioned email ids.
What is effect of harmonic current (Draw by VFD) on power system/ electrical Equipments ?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
how to select the automotive wire size by mathematical calculation. for xenon headlamp with ballast. the ballast given data voltage 10-17v,current permenant 6amp, run up phase is 15amp, peak at swicth on max 400micro sec is 40amp.the sum of cable resistance is 150mohm.please provide referenc document if any for relating the peak at switch on current,time & wire wire size
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
What is signal flow graph?
what are the pecularity of shaver sockets ?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
what will be d.g. capacity to cater together for 14hp A.C. load & 3kw lighting load
