Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abdul rahim
we can connect the third party in dcs by using the Profibus
serial communication.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
With N nodes and B branches what will have a network ???
How process line mpm calculation is done?
plz send me general of ongc
I faced several time siemens ps2 positioner automatically getting Chang in it's set point direction after auto calibration So is there any causes biside this or any permissives ?
What is zener diode? What is voltage regulator?
What is Erosion in a control valve?
what is cold loop? difference between hot and cold loop?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
WHAT IS THE DIFF. BETWEEN SKIN TEMPERATURE AND PASSES TEMPERATURE..?
What is the difference between modbus,fieldbus & profibus
we are using centum vp as monitoring with Dell precision work station T3600 but some times PC(s) are restarted automatically . how we can solve this problem? thanks
