a wire in which bulb is connected
there is two terminal
when one terminal is connected to phase than why the value of
current shock in nutral terminal is max. or large??
Answer Posted / dj
U cant get any shock it is just like a tester when u touch the tester metal body u work like a neutral as well as here in bulb
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
what is per unit calculation?looking for simple and strong explanation thk u
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
Advantages of using generator circuit breaker (GCB) scheme in a power station ?
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
How to decide CT & PT ratings for a given transmission line carrying some rated voltage?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
Any one can explaination about calibration with rotating sub standards?
in non technical way how can u define POWER FACTOR??
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
How many types of colling system it trformers?
How would your past experience translate into success in this job?
What is BusBar integrity test and how it is conducted?
Can anybody please refer the best and simple book for about Protection relays and in detail of all its protection ?