What it the purpose of parallel phasing transfomers??
- 4 Answers
- 6527 Views
- ABB, Reliance, I also Faced
- E-Mail Answers
Answer Posted / manan bhatt
for achieving reliable and continuous operation.
when on 1 transformer load is 200 MW
and additional requirement is another 50 MW,
then instead of replacing 200 MW transformer it is economical
to parallel them with 200 MW || 50 MW
same principle is every where in india and across the world of
INTER CONNECTION!!
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
300m long and 30kw inductive loade 3phase supply how many size cable required
Where is servomechanism used?
WHY THREE PHESE SYSTEM VOLTAGE APPLIED IN 440 VOLT
please send me the L&T Emb. sys. placement papers and entire details of pattren
Define bibo stability.
why normally Generator rating are between 11Kv to 22Kv?
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
what is the cause of voltage dipp or swell in the transmission lines?
What are the Full Forms of TVM, MTL, CVT ?
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
please send me previose rrb junior engineer qustion papers
How to decide cable tray size?
