Interested to Buy Any Domain ? << Click Here >> for more details...
why fan consume constant power even when we increase or
decrease its circuit resistance through speed regulator???
- 2 Answers
- 4460 Views
- I also Faced
- E-Mail Answers
Answer Posted / manan bhatt
for fans with old resistive regulators,
total power consumed = heat loss at regulator + fan motor
consumption.
so by setting any speed that much amount of R will introduced
and produce heat loss and remaining will produce motor power.
If electronic regulators are used regulator loss can be
decreased by decreasing speed of fan.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between verilog task and verilog function?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
Refernce currents are to be generated using refernce cueernts how can this be done??
what is conductor constant of raccun conductor
why single phase to grd test in HV cable?why not 2 phase at a time?
Hi Suppose we have a wye/wye transformer which is grounded at both sides,in this situation, do we have ay ground transformer? in other words, ground transformer can do any thing more (while we have nuetral wire in both sides)? As the last question, what about 3rd harmonic? we have two choices: first using wye/delta transformer + ground transformer and second using wye/wye earthed connection.in the former choice, we dont have 3rd harmoonic at the secondary side but what about Yn/yn conection? do we suffer from 3rd harmonic in the Yn/yn connection?
Describe the test procedure to determine the vector group
What is the purpose of stand by earth fault protection for transformer ?
how the phase convertor changes the no. of phases
where was current transformer protection units used and why??
Which type of questions well asked. ?
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
how to calculate mf when meter and cTPT detail are given
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
