why we use condenser in the thermal power plant, althrough
the same vapour will be again heated
- 2 Answers
- 4141 Views
- I also Faced
- E-Mail Answers
Answer Posted / lakshmi
in thermal power plants we use condenser for the purpose of
cooling the exhausted steam coming from the turbine.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
i have 3500 amp load and select current transformer and perches.how i calculate .please understand
Can a generator runs after getting 1st stator earth fault.
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in
Dear All we are having a problem in G120 BOP showing alarm A0503, F0052, F0060 we can not remove fault alarm ,Please any body help us. kowsar
what are the specifications we must look at to select a relay for any capacity motor?
What is the resistance of the field winding of a d.c. Shunt generator kept low?
what is high and low cut off voltage of BB and DG at SPS????????
What is difference between Over Current & Earth Fault protection?
how does a submersible pump work..?
132/66kv sub-station procation ?
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
We are planning to synchronized DG's with our captive plant in the event of black start of plant, but before sync we checked voltage of DG with our plant voltage and it varies from 5 V to 450 V. So in this condition how we can sync DG with plant ?
How to Calculate the Fault Level of Electrical Installation
What is the disadventage of gland earthing(power cable) if any. ?
Explain what is electric traction? Explain few advantages of electric traction system?
