in india,we use 230V,50 Hz,whereas many other countries use
110V,60Hz.what r d advs and disadvantages of each of them?
- 11 Answers
- 24839 Views
- I also Faced
- E-Mail Answers
Answer Posted / mir jahan
Third world countries like India, Pakistan etc, due to
extreme poverty, they cannot afford power lose. so we use
220 volts/50hz while in Advanced countries, money is not an
issue. Therefore, they use 110 as a safety measure.
As, power out put= (square of current)(voltage)
Decreasing of voltage increases the current and power loss
is square of the factor.
| Is This Answer Correct ? | 3 Yes | 7 No |
Post New Answer View All Answers
11000volt DG set carnt kaise banvay
What is self exciting?
please send me last 5 year interview questions
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
Form S and "c" license application both are same? @ tneb portal
List the time domain specifications.
how to calculation increase power factor for single phase
why dc is used in control circuit for mv & hv switchgear instead of ac
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
What is the resistance of the field winding of a d.c. Shunt generator kept low?
what is the IS foe lightning arrester?
What are locations arc protection relay is fixed.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
what is acceptable leakage current for 33kv cable while doing high voltage test for cable? how to calaulate the leakage current for 33kv or any rated cable?
