Answer Posted / rajendra mane
generator intended to operate
in parallel must have reverse
power protection.
A reverse power relay monitors
he direction of power flowing
between the generator & the
load .If prime mover failure
occured the generator will act
as motor.The reverse power
relay detect this fault & act to
trip the generator circuit
breaker.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
why the active power flow of some line is increased when the active power of out is cut ?
What is the necessary condition for stability.
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
how ceiling fan worked?
What is the ideal position cooling fan inside the dc motor?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
What is size 00, 01, 1 etc., in HRC fuse types?
how to setting voltage RTCC panel
Differnce between negative Pahse SequenceFunction and unbalance Function?
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
Explain about 3 phase motor fault current calculation with examples?
Define the three phase formula fuse.
why magnetising curve not start with zero voltage?
hi can any body send me syllabus of rrb electrical section engg... and past pepar also of any board...
i want use the cable size 16cx4 core aluminium usege watts 240x2000w this cable size is correct?
