Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sabry
The word "strain" means "extraction/contraction".
For "strain gauge" we have a fine layer of strain material which is proposed to the pressure by "diaphragm" or "fill fluid media", then it contracts/extracts according to pressure variation.
By contraction/extraction the resistance of the strain piece changes as R=(SPECIFIC DENSITY*LENGTH)/AREA, So this R varioation is taken through whetistone brigde and voltage /ampere variation.
For the strain piece all changes are in microscopic scales.
Example of the strain material is "silicon".
Ahmed Sabry
I&C Senior Engineer
Cell:+2 (0122) 1367310
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Im having problems with interfase betwen SPI v7.0 and SPPID v5.05. Previous versions of Intools shoul be fixed with SPPIDproj.ocx file. It was necessary to replace this file with one that allows the connection between different versions of SPPID. It is necessary in the current version to do the same?Thanks
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
can anyone guide me how to get any of the previous year GAIL question papers? are they available? 0n 2nd august i have to take the written test.
what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?
What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?
Why rdt and thermocouple both give different output .and one things more, how to generate ohm or mili volt plz mail me merajalam143545@yahoo.com
what is zero and span ?
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
why we are using magnet for calibration of gas detector?
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
what is wave length were using ?
what is the reason while warning lamp is on while the engine is cranking?
List three types Level Switches with their working principles
Describe how to use megger to measure the earth resistance and insulation resistance
