Interested to Buy Any Domain ? << Click Here >> for more details...
what is difference of electrical and electronics
- 6 Answers
- 7654 Views
- SSIL, I also Faced
- E-Mail Answers
Answer Posted / ashok mishra
below 5volts called electronics and after 5 volts called electrical
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is T’Q and X’Q and X’D ? and what is saturated as well as unsaturated ?
Disadventage of cable-gland earthing if any ?
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
write a c++ code that receives an integer number and display the sum of the number and its revers integer?
what is the difference between vector scale and vector diagram?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
what is the difference between neutral and earth
how to find the voltage's of a transmission line plzz help with pictures i am not able to understand
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
explain remenance . differentiate high remenance type ct & low remenance type ct
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
