Interested to Buy Any Domain ? << Click Here >> for more details...
why buchholz relay is kept on inclined position and why it
is cover??
- 1 Answers
- 4556 Views
- GSECL, I also Faced
- E-Mail Answers
Answer Posted / chirag desai
buccholz relay is kept inclined to trap the gas,bcz gas has
tendency to go upward and same amount of oil push to
conservator tank so, buccholz float comes downward and
gives an alarm.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
when will be the iocl interview results ifaced the interview on september 8 th
Which type of transformer is used for lighting loads?
What is the meaning of loop in transformer
what is difference between earthingpits,earthing grid & earthing mess?
What is VSCF windelectrical system?
what curve and rateing would you use for a three phase 0.75kw motor?
magnetizer priciple
5- What is the task (function) of the excitation and isolation transformers in power plant? 6- What is the task (function) of LCI (A), LCI (B) and LCI (COS) in power plant? : LCI (A) and LCI(B) are load commutating inverter for generator turbine starting. , LCI (COS) is load commutating inverter change over switch
what is the differation bewreen kwh & fundamental kwh in electronic trivector meters
what happen when increase or decrease size of lamp,light.glass.
how maney type tempereture measurement ?
L.A. (Lightening Arrester) is located at a place from where transmission line enters the transmitting substation. So L.A. (Lightening Arrester) is the first equipments which has to encounter with lightening, high voltage surges and switching surges. It has to absorb energy of lightening, high voltage surges, and switching surges. L.A. (Lightening Arrester) is made up of layers of semiconductors. If these layers can not tolerate energy released by lightening, high voltage surges, and switching surges the L.A. (Lightening Arrester) blasts.
a governer in an Ic engine controls the
sir plz send some previous year questions of jspl.
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
