Interested to Buy Any Domain ? << Click Here >> for more details...
what is orifice plate?
Give me best answer?....plz
- 5 Answers
- 11397 Views
- I also Faced
- E-Mail Answers
Answer Posted / sam
Orifice plate is a fluid flow measuring device. It works on
the following principle.
Flow rate(Q)= sqr rt (Differential pressure).
When the fluid flows across the orifice plate it will create
the differential pressure,, based on the nozzle action
principle. ie.., The pressure in the upstream is more than
when compared to the pressure in the down stream. why
because the orifice plate will create a trap for the normal
fluid flow, so before orifice plate the velocity of the
fluid will be less and the pressure is more., due to the
change of kinetic energy to potential energy,. and after the
orifice plate the fluid particles will try to regain their
energy back so after orifice plate the velocity will be more
and the pressure will be less., thus the differential
pressure is created.
And by using the SQUARE ROOT EXTRACTION PRINCIPLE we are
converting this differential pressure in to flow.
Four types of orifice plates are there.
1) concentric
2) segmental
3) essentric
4) quadrant
| Is This Answer Correct ? | 38 Yes | 0 No |
Post New Answer View All Answers
Galvanizing.
How is automatic reference junction compensation carried out in temperature recorders?
why we are using digital signals for I/O & how to measure this signals is getting or not ?
Give 2 application of quartz crystal used for process parameter measurement.
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
How RAL(Rotary air lock)works in cement industry?
What are primary elements of measuring pressure? Which type of pressure can be measured by these elements?
Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.
plz send me general of ongc
What do you know about gail?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
What materials are used in thermo wells?
