Interested to Buy Any Domain ? << Click Here >> for more details...
How does a redundant controller comes in line when the main
controller fails??
- 3 Answers
- 9592 Views
- Yokogawa, I also Faced
- E-Mail Answers
Answer Posted / rohit kumar
A redundant controller is a pair of standard controllers
on separate 2-wide power/controller carriers that are
connected together. Each controller
requires its own power supply mounted on its carrier. One
of the controllers in the pair is the active controller and
the other controller is the standby controller. There is
no physical difference between the active and
standby, nor is there a preferred position for the active
controller. The controller that boots first becomes the
active controller.
The redundant controllers communicate with each other via a
dedicated high-speed serial bus
The standby controller contains the same configuration as
the active controller and tracks the operation of the
active controller. When an active controller fails, the
standby controller takes over, providing uninterrupted
control
operation without initialization or user intervention. When
the previously active controller recovers to a healthy
state or is replaced, the two controllers automatically
become a redundant pair again.When the active controller
failed the user will recieve an alarm at the HIS
| Is This Answer Correct ? | 16 Yes | 3 No |
Post New Answer View All Answers
control panel design guidelines
What is stripper & spilitter ? Diffrence in this.?
How do you identify an orifice in the pipeline?
Questions on flow meters,few questions on HART protocol,
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
how to commission furnace ( water heater)
give me all the details about the interview and which type of question being asked
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
In which principles tx ,pressure gauge,Temp gauge,control valve works?
