can three phase induction motor rotate with only 2 phases
connected
- 22 Answers
- 51608 Views
- Delta, Mannar Company, Suntron, I also Faced
- E-Mail Answers
Answer Posted / bhasheer
only two phase will never create rmf in three phase motor... we need a capacitor to create three phase rmf. while using the capacitor the motor starts to rotate but the starting torque will reduces....
During the normal running condition of three phase motor, if one phase fails, the motor will run continuously when there is no load in the shaft.
At the same time if the motor is connected through the starter,the over load relay in the starter trips and the motor will stops....
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
bitumar
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
how to find the multiplication factor for digital energy meter and analog energy meter
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
Explain what is electric traction?
write a c++ code that receives an integer number and display the sum of the number and its revers integer?
Actually I have a doubt on neutral and earth.we use Ac power without taking neutral by connecting to earth,but at that time does it affects on efficiency of any electrical components or no? If yes how?
Define conversion efficiency of a power amplifier.
low frequency protection why recomend?
DEAR SIR/MADAM,CLEARLY EXPLAIN ABOUT CRAWLING AND COGGING EFFECTS IN INDUCTION MOTOR.
reason of diode failure in alternator
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
What is meant by reactance voltage?
