Interested to Buy Any Domain ? << Click Here >> for more details...
Why usually in all electrical equipment taking more current
in Y pahse like pumps,compressor,or any other applications
- 1 Answers
- 3643 Views
- I also Faced
- E-Mail Answers
Answer Posted / laxmikanta sasmal
logically this is not possible unless check voltage across all phase at that time.because generally we mostly use Y phase current/voltage feed backs for accurate/fine measurement or protection system
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
what is d check in dg 1500kva
As an electrical engineer what are the responsibilities which i can hold in TCS?
State The Difference Between Generator And Alternator?
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
primery try cell?
What is mean by hot and cold loop testing?
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
why to use freewheeling diode ( diode in revers bias mode) across dc coil
What is the test block protection relay if any body know plz explained
Ratings of power transformer,Distribution transformer.
what is RFID? thire application;
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
