Answer Posted / navneet phogat
Three phase induction motors are used wherever the application depends on AC power from the national grid. Because they don't need commutators they are particularly suitable for high power applications.
They are available with power handling capacities ranging from a few Watts to more than 10 MegaWatts.
They are mainly used for heavy industrial applications and for machine tools.
The availability of solid state inverters in recent years means that induction motors can now be run from a DC source. They are now finding use in automotive applications for electric and hybrid electric vehicles. Induction motors are seen as more rugged for these applications than permanent magnet motors which are vulnerable to possible degradation or demagnetization of the magnets due to over-temperature or accidental over-current at power levels over about 5 kW. Nevertheless, the induction motor can be ill-suited for some automotive applications because of the difficulties associated with extracting heat from the rotor, efficiency problems over wide speed and power ranges, and a more expensive manufacturing process due to distributed windings. Permanent magnet and reluctance motors may offer better solutions for these applications.
| Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
CPC cable .PVC \1C....I want to get sure that type is flexible indoor or to be install on trench. please advice .thanx :)
in what type of applications v can use q meter?
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
what is current check gurd relay?
What types of high speed CMOS circuits have you designed?
What does Bode plot tell you?
What current flows in the transformer primary when its secondary is open?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
Single line diagram for dbb (double bus bar)system.
How to calculat the ratio of HT\LT in energy meter
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
