Answer Posted / srilakshmi
Use the following formula to estimate the amount of wall paint you need. Double the result if the walls require two coats.
1. Add together the length of each wall.
14 + 20 + 14 + 20 = 68 feet
2. Multiply the sum by the wall height, to find the total wall area.
68 × 8 = 544 square feet
3. Subtract 20 square feet for each door (20 × 2 = 40) and 15 square feet for each window (15 × 2 = 30) to find the actual amount of wall area you're painting.
544 – 70 = 474 square feet
4. Divide this figure by the paint coverage (350 square feet per gallon), and the result is the number of gallons to purchase.
474 ÷ 350 = 1.4
For this example, you want to buy 1 gallon and 2 quarts of paint for a single coat.
| Is This Answer Correct ? | 17 Yes | 1 No |
Post New Answer View All Answers
what s the standrd size of pvc fittings ,like elbow, bend,tee etc ? please explain with figure ?
what is the design procedure for building
What are the uses of groynes?
Why do you want to work here
how do i remedy a foundatiom that the column bases was cast and aftet 28days crushing the conprehensive strength of the concrete fall below the specification 25N/mm2
Is there any course for billing available in Mumbai? If yes then please mail me the details..
what is density of 20mm coarse aggregate.plz send answer my below adress e.mail
hai, kindly send anyone for output workers format details for construction project in foundation to finishing.
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
reinforcement slab, beam and column formulas?
i have applied 40mm spacer in the concrete for tie beam. is it correct? kindly give me if there any code available
Dear Sir What is the Contraction joint for base Slab
can any one tell me in detail footing estimation .. i am new here in dubai so facing lots of problem...
How to calculate carrying capacity of the existing water supply trunkmain
Can anyone suggest how to determine scheduling of reinforcement of floor beams from Staad model,other than clicking each beam respectively 7 noting down the values ?
