Interested to Buy Any Domain ? << Click Here >> for more details...
in the Distribution system .which one is Most Economically
used by Power Engineer ?
a)3 Phase3 wire System or b) 3Phase -4wire System
- 6 Answers
- 7965 Views
- APTransco, I also Faced
- E-Mail Answers
Answer Posted / roy
it is depend upon the loads which u r connecting to the
system. if the loads are motor loads. 3phase 3wire you can
use.
but mostly all distributions are 3phase 4wire because loads
needs neutral.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
XYZ
DRAW ACIRCUIT DIAGRAM OF 100 KVA 415V/55-0-55V DELTA TO STAR TRANSFORMER
Do you need any help with FEWA Electrical Supervisor exams?
What is the count of hvdc transmission lines in india?
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
along with technical test papers
In synchronization circuit what is the function of Interposing voltage transformer(IVT)and Reverse voltage transformer(RVT)
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
what the Microsoft .NET framework is?
in conventional fan regulators how the current varies with speed?
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
